30-40W CO2 Laser Power Supply for CO2 Laser Engraving Cutting Machine HY-T35

Your position: Home > CO2 Laser Power Supply

Description
Order record

30-40W CO2 Laser Power Supply for CO2 Laser Engraving Cutting Machine HY-T35

Specification:

Input	Input Voltage	AC220V(Need AC110V ,please specify ,when order)
	AC frequency	47 - 440HZ
	Max Input power	250W
	Max Input current	3A
Output	Max output voltage	DC25KV	DC5KV	DC24V
	Max output current	DC20mA	DC1A	DC2A
Efficiency		>/=90%(Full load)
MTBF		>/=10000 Hours
Response speed		≤ 1ms (Time from the TTL Signal is given to the output current up to 90% pre-setting current)
Withstand Voltage		Input-Output, Input-Enclosure: AC1500V 10mA 60S, Output cathode is connected with enclosure.
Environment		Operating temperature: (-10-40)degree Celsius,Relative humidity: ≤90%
Cooling		Natural Cooling

40W CO2 Laser Power power Main Features:

1. Good compatibility: it can be applicable to 40W and 30W laser tube manufactured by various factories.
2. Quick response speed and effect,high performance,large cutting power,it also can prolong laser tube service life.
3. Easy control: the start and stop of laser can be easily controlled by TTL level.
4. The power supply has output open circuit protection.
5. The power supply has TTL signal indication, water through signal indication and laser output indication.
6. This power supply has the Buttonto test output laser manually.
7. Application: Sculpture and cut acrylic,fabric,double color sheet and rubber etc.

Connection between Power Supply and Laser Tube:

Terminal Definition:

P1:

1	2	3	4
G	AC	AC	FG

G: connect the negative pole of the laser tube.

AC AC: AC input.

FG: connect with G internal, and connect the power supply shell.

P2:

1	2	3	4	5	6
5V	IN	G	WP	TL	TH

Terminal definition as follow:

TH	Input Signal	Disconnection,it is customizable.
TL	Input Signal	The control of laser: Low Level, emitting laser
WP*1	Input Signal	Switch Light Control,High Leve-No light Dipping,Low Level-Bright Dipping.External with water-protction switch.
G	Signal Ground	The foot must connected with laser machine's enclosure and ground properly.
IN*2	Input Signal	Laser Power supply control terminal can use 0-5V Analog Signal Control,also can use 5V PWM Signal to Control
5V	Output Power	5V,Max output Current 50mA