Your position: Home > CO2 Laser Power Supply
- Description
- Order record
60W CO2 Laser Power Supply for CO2 Laser Engraving Cutting Machine HY-T60

Specification:
60W CO2 Laser Power power Main Features:
Input | Input Voltage | AC220V(Need AC110V ,please specify ,when order) |
AC frequency | 47 - 440HZ | |
Max Input power | 450W | |
Max Input current | 3A | |
Output | Max output voltage | DC35KV |
Max output current | DC24mA | |
Efficiency | >/=90%(Full load) | |
MTBF | >/=10000 Hours | |
Response speed | ≤ 1ms (Time from the TTL Signal is given to the output current up to 90% pre-setting current) | |
Withstand Voltage | Input-Output, Input-Enclosure: AC1500V 10mA 60S, Output cathode is connected with enclosure. | |
Environment | Operating temperature: (-10-40)degree Celsius,Relative humidity: ≤90% | |
Cooling | Forced air cooling (fan cooling) |
60W CO2 Laser Power power Main Features:
1. Good compatibility: it can be applicable to 60W laser tube manufactured by various factories.
2. Quick response speed and effect,high performance,large cutting power,it also can prolong laser tube service life.
3. Easy control: the start and stop of laser can be easily controlled by TTL level.
4. The power supply has output open circuit protection.
5. The power supply has TTL signal indication, water through signal indication and laser output indication.
6. This power supply has the Buttonto test output laser manually.
7. Application: Sculpture and cut acrylic,fabric,double color sheet and rubber etc.
Connection between Power Supply and Laser Tube:
Terminal Definition:
Terminal definition as follow:
Connection between Power Supply and Controller:
2. Quick response speed and effect,high performance,large cutting power,it also can prolong laser tube service life.
3. Easy control: the start and stop of laser can be easily controlled by TTL level.
4. The power supply has output open circuit protection.
5. The power supply has TTL signal indication, water through signal indication and laser output indication.
6. This power supply has the Buttonto test output laser manually.
7. Application: Sculpture and cut acrylic,fabric,double color sheet and rubber etc.
Connection between Power Supply and Laser Tube:

Terminal Definition:
1 | 2 | 3 | 4 | 5 | 6 |
TH | TL | WP | G | IN | 5V |
Terminal definition as follow:
TH | Input Signal | Switch Light Control,High Level(>=3V)-Bright dipping,Low Level(<=0.3V)-No Light Dipping |
TL | Input Signal | Switch Light Control.High Level-No light Dipping,Low Level(<=0.3V)-Bright Dipping |
WP*1 | Input Signal | Switch Light Control,High Level(>=3V)- No light Dipping,Low Level(<=0.3V)-Bright Dipping |
G | Signal Ground | The foot must connected with laser machine's enclosure and ground properly. |
IN*2 | Input Signal | Laser Power supply control terminal can use 0-5V Analog Signal Control,also can use 5V PWM Signal to Control |
5V | Output Power | 5V,Max output Current 20mA |
Connection between Power Supply and Controller:
